Lines Matching refs:DMA

144 good default configuration to use. Please try to use same I/O, DMA and IRQ
159 	- "Device or resource busy". Probably the IRQ (or DMA) channel 
162 	- "I/O error". Almost certainly (99%) it's an IRQ or DMA conflict.
288 - You get the famous "DMA timed out" messages. Usually all SB clones have
289 software selectable IRQ and DMA settings. If the (power on default) values
292 few other reasons to the DMA timeout message but using the SB mode seems
338 soft configuring their I/O, IRQ, DMA and shared memory resources.
359 work now. "Proper" means that I/O, IRQ and DMA settings are the same as in
375 support for PnP cards. There are bugs in setting DMA channels in earlier
644 configure the driver use I/O, IRQ and DMA settings
657 the driver to use I/O, IRQ and DMA settings which are known to work.
693 DOS based driver initializes the hardware to use known I/O, IRQ and DMA
826 	  Note! The MSS driver permits configuring two DMA channels. This is a
828 	  In most cases the second DMA channel should be disabled or set to
869 Entering the I/O, IRQ and DMA config parameters
874 I/O address, IRQ and DMA numbers are asked. With some cards the program
886 Please refer manual of your card for valid I/O, IRQ and DMA numbers. Using
899 DMA settings. Since the possible/default settings have changed between various
902 it's the only choice. SB16 has software selectable IRQ and DMA channels but
905 if Linux has used different IRQ or DMA values.
910 The SB16 needs two DMA channels. A 8 bit one (1 or 3) is required for
912 it's possible to use just one (8 bit) DMA channel by answering the 8 bit
948 	- If you use the same I/O, IRQ and DMA settings in Linux, the
996 for the I/O, IRQ and DMA numbers for the card. Use the same values than
1000 IRQ and DMA numbers for the daughter card. You have to use different I/O
1001 and DMA values than for the standard GUS. The daughter card permits
1006 (GUS MAX = GUS + a CS4231 codec). In addition an extra DMA channel may be used.
1007 Using two DMA channels permits simultaneous playback using two devices
1008 (dev/dsp0 and /dev/dsp1). The second DMA channel is required for
1010 To enable the second DMA channels, give a valid DMA channel when the config
1011 program asks for the GUS MAX DMA (entering -1 disables the second DMA).
1012 Using 16 bit DMA channels (5,6 or 7) is recommended.
1015 just one 8 bit DMA channel. Recording will not work with one DMA
1083 DMA numbers. Using the same values than with DOS/Win is a good idea. Don't
1084 attempt to use the same IRQ or DMA channels twice.
1088 both the SB driver and the SB mode of ATP to use the same IRQ, DMA and I/O
1129 The configuration program asks one DMA channel and two interrupts. One IRQ
1130 and one DMA is used by the MSS codec. The second IRQ is required for the
1132 There were earlier two DMA channels for SoundScape but the current driver
1203 can be enabled by configuring the card to use two DMA channels. Possible
1204 DMA channel pairs are: 0&1, 1&0 and 3&0.
1217 'y' here and the driver asks the second (16 bit) DMA channel.
1234 you have a SM Wave immediately after asking the second DMA channel of jazz16.
1398 DMA numbers as DOS, the card could work.