Lines Matching refs:and

16 card#0) for front and 4/6ch playbacks, while the second PCM device
21 - The first DAC supports U8 and S16LE formats, while the second DAC
27 44100 and 48000 Hz.
35 will be FULL VOLUME regardless of Master and PCM volumes.
41   front one) and was so excited.  It was even with "Four Channel" bit
42   on and "double DAC" mode.  Actually I could hear separate 4 channels
43   from front and rear speakers!  But.. after reboot, all was gone.
54 The "Exchange DAC" switch is used to exchange front and rear playback
74 The 4.0 and 5.1 modes are defined as the pcm "surround40" and "surround51"
80 channels as you like and set the format S16LE.  For example, for playback
88 and use the interleaved 4 channel data.
96 	When "Rear Output" is chosen, the surround channels 3 and 4
101 	When "Center/LFE Output" is chosen, the center and bass
102 	channels (channels 5 and 6) are output to mic-in jack. 
110 The SPDIF playback and capture are done via the third PCM device
112 The available rates are 44100 and 48000 Hz.
123 The playback and capture over SPDIF use normal DAC and ADC,
124 respectively, so you cannot playback both analog and digital streams
137 (441100 or 48000) and channels (2) are used.  Otherwise it's turned
143 "IEC958 Mix Analog" - Mix analog PCM playback and FM-OPL/3 streams and
145 	models (CM8738 033 and 037).
151 	and the external input (true).
159 	On some cards this doesn't work and you need to change the
182 Similarly the following switches are off: "IEC958 Mix Analog" and
196 There are Master, PCM, Synth, CD, Line, Mic and PC Speaker playback
197 volumes.  Synth, CD, Line and Mic have playback and capture switches,
205 - Aux playback volume/switch and capture switch
214 to enable MIDI support.  Valid I/O ports are 0x300, 0x310, 0x320 and
217 With CMI8738 and newer chips, the MIDI interface is enabled by default
218 and the driver automatically chooses a port address.
236 CMI8768 and newer chips do not have the FM synth.
239 Joystick and Modem