Lines Matching refs:only
50 * 24-bit/96kHz ==> 2 channels in _or_ 2 channels out (half duplex only)
57 - Note that in this setup only the Do interface can be enabled
60 - As a consequence, the Di port must be enable only if an active Digital
113 compliant (supposedly supporting S16_LE) but processes in fact only S16_BE streams.
173 In this modes the device operates only at 16bits-modes. Before kernel 2.6.23,
210 In these modes the device is only Big-Endian compliant (see "Default Alsa driver
218 - 16bits 48kHz mode with only the Do port enabled
248 correct device_setup parameter and then (and only then) turn on the device again.
284 - it is set only for Digital output with DTS/AC3
292 - Note that b2 implies b3 as the 96kHz mode is only supported for 24 bits
299 - b4 is implied by b2 (since only one port is enabled at a time no synch
310 only be able to use one at the same time
362 * if DTS is chosen, only Interface 2 with AltSet nb.6 must be
364 * if 96KHz only AltSets nb.1 of each interface must be selected
366 Digital input is connected, and only AltSet nb.3 if Digital input
369 Digital input is connected, and only AltSet nb.5 if Digital input
389 Jack supports big endian devices only in recent versions (thanks to
418 As you can see, starting the Jack server this way will only enable 1 stereo
422 * Jack can only open one capture device and one playback device at a time