Lines Matching refs:up

169 named LOAD and STORE that allow to move up to 1 DWORD from/to an IO register 
228 maximum number of queued commands up to 32. The Symbios Setup only allows 
236 This driver supports up to 255 commands per device, and but using more than 
276             corresponding to your controller after boot-up.
378     th driver verbose level after boot-up.
401 features supported by the driver can be enabled at start-up. However,
403 support by the driver of this feature at linux start-up and enable
404 this feature after boot-up only for devices that support it safely.
436 - enable tagged commands, up to 4 tagged commands queued.
466         diff=0	never set up diff mode
467         diff=1	set up diff mode if BIOS set it
468         diff=2	always set up diff mode
689 serial NVRAM is used by Symbios and Tekram to hold set up parameters for the 
722 In order to speed up the system boot, for each device configured without 
802         controller set up  -  20 bytes
804         device set up      - 128 bytes (16x8 bytes)
816 controller set up
836 current set up for any of the controllers.
838 default set up is identical for 53c810a and 53c875 NVRAM
859 current set up
861 default set up is identical for 53c810a and 53c875 NVRAM
863 device set up (up to 16 devices - includes controller)
900 current set up
905 default set up for 53c810a NVRAM
906 default set up for 53c875 NVRAM - bus width     - 0x10
917 default set up is identical for 53c810a and 53c875 NVRAM
925 default set up is identical for 53c810a and 53c875 NVRAM