Lines Matching refs:BUS

39              10.2.6  Check SCSI BUS 
47       10.4 SCSI BUS checking boot option
385     The driver will try to send a BUS DEVICE RESET message to the target.
476 10.2.6 Check SCSI BUS 
560 10.4 SCSI BUS checking boot option.
565 Since SCSI devices shall release the BUS at most 800 nano-seconds after SCSI 
566 RESET has been asserted, any signal to TRUE may indicate a SCSI BUS problem.
567 Unfortunately, the following common SCSI BUS problems are not detected:
630              Data parity error detected on the PCI BUS.
639   BF (0x20), then the cause may be likely due to a PCI BUS problem.
644              on the SCSI BUS that prevents the SCSI protocol from functioning
647              Indicates that the device released the SCSI BUS when the chip 
650   Bit 0x02 : RST  SCSI BUS Reset
651              Generally SCSI targets do not reset the SCSI BUS, although any 
652              device on the BUS can reset it at any time.
655   On a faulty SCSI BUS, any error condition among SGE (0x08), UDC (0x04) and 
658   BUS problem is likely the cause of these errors.
666           Actual value of control lines on the SCSI BUS.
668           Actual value of data lines on the SCSI BUS.