Lines Matching refs:SCSI
1 This file contains brief information about the SCSI tape driver.
57 supported devices. The Linux SCSI tape driver does not contain such
88 Writing filemarks without the immediate bit set in the SCSI command block acts
143 'device' and 'driver' point to the SCSI device and driver entries.
150 A link named 'tape' is made from the SCSI device directory to the class
181 several blocks and using one SCSI read or write to transfer all of the
210 allocated. To support all SCSI adapters (including those not
213 1. The initial segment that is used for all SCSI adapters including
227 number of scatter/gather segments allowed for the SCSI adapter is not
229 segments specified. If the maximum number allowed for the SCSI adapter
294 to find an mt that supports all of the Linux SCSI tape ioctls and
325 for SCSI-1 drives and SCSI-2 seek for SCSI-2 drives. The file and
338 SCSI mode page 15. Note that some drives other methods for
373 MT_ST_FAST_EOM using the SCSI spacing to EOD (global)
384 the MTSEEK and MTIOCPOS for SCSI-2 drives instead of
395 MT_ST_SILI enables setting the SILI bit in SCSI commands when
458 Tandberg-compatible QFA for SCSI-1 drives and the SCSI-2
459 command for the SCSI-2 drives.
485 Immediate return from tape positioning SCSI commands can be enabled by
488 finished. The drives and SCSI adapters should handle this condition
490 SCSI bus in this case.