Lines Matching refs:commands
19 8. Control commands
22 8.3 Set maximum number of concurrent tagged commands
31 10. Boot setup commands
39 10.2.6 Default number of tagged commands
56 10.3 Advised boot setup commands
65 14.1 Tagged commands with Iomega Jaz device
127 drivers, configuration parameters and control commands available through
184 Control commands: write operations to the proc SCSI file system
188 Boot setup commands
256 maximum number of queued commands up to 32. The Symbios Setup only allows
259 The maximum number of simultaneous tagged commands queued to a device
264 The sym53c8xx driver supports up to 255 commands per device, and the
268 more than 64 simultaneous commands. So, using more than 64 queued commands
277 will set tagged commands queue depths as follow:
290 to the actual number of disconnected commands.
292 - Every 1000 successfully completed SCSI commands, if allowed by the
293 current limit, the maximum number of queueable commands is incremented.
297 number of commands used and their status, as well as its decision on the
314 (See 10: Boot setup commands).
344 Synchronous transfer period 25, max commands per lun 4
372 The profiling information is updated upon completion of SCSI commands.
384 Number of completed commands
385 Example above: 18014 completed commands
408 Elapsed time for SCSI commands setups
432 8. Control commands
434 Control commands can be sent to the driver with write operations to
441 Using "all" for "<target>" parameter with the commands below will
444 Available commands:
468 8.3 Set maximum number of concurrent tagged commands
473 tags: number of concurrent tagged commands
576 This option allows you to specify the maximum number of tagged commands
620 10. Boot setup commands
624 Setup commands can be passed to the driver either at boot time or as a
635 - enable tagged commands, up to 4 tagged commands queued.
655 The sequence of commands,
697 10.2.6 Default number of tagged commands
700 #tags will be truncated to the max queued commands configuration parameter.
706 - controller #0 target #2 and target #3 -> 16 commands,
707 - controller #0 target #5 -> 24 commands,
708 - controller #1 target #1 logical unit #2 -> 32 commands,
709 - all other logical units (all targets, all controllers) -> 10 commands.
853 win arbitration and it has other commands to send to a device.
880 10.3 Advised boot setup commands
919 and PCI write and invalidate commands. These features require the
922 invalidate commands only if the corresponding bit is set to 1 in the
1071 Maximum number of simultaneous tagged commands to a device.
1080 Default number of simultaneous tagged commands to a device.
1084 Use SIMPLE TAG for read and write commands.
1118 Avoids timeouts for unordered tagged commands.
1121 Max number of commands that can be queued to a host.
1124 Max number of commands queued to a host for a device.
1161 14.1 Tagged commands with Iomega Jaz device
1165 while spinning up, it rejects Tagged commands. This behaviour is
1249 - tagged commands disabled
1266 tagged commands queuing.
1268 Try to enable one feature at a time with control commands. For example: