Lines Matching refs:boot

56       10.3 Advised boot setup commands
57       10.4 PCI configuration fix-up boot option
58       10.5 Serial NVRAM support boot option
59       10.6 SCSI BUS checking boot option
60       10.7 IMMEDIATE ARBITRATION boot option
273 depths from the boot command-line. For example:
303 1st method: boot your system using 'ncr53c8xx=verb:0' option.
305             corresponding to your controller after boot-up.
313 checking by entering appropriate options from the boot command line.
537     th driver verbose level after boot-up.
563 this feature after boot-up only for devices that support it safely.
581     will use at boot time for synchronous data transfer negotiations.
612     Tekram cards. Enables setting the boot order of host adaptors
624 Setup commands can be passed to the driver either at boot time or as a 
627 A boot setup command for the ncr53c8xx (sym53c8xx) driver begins with the 
630 list of comma-separated strings. Example of boot setup command under lilo 
686    must be specified in the boot setup command to enable Memory Write And 
816         0x08   ignore NVRAM "Scan at boot time" parameter for all devices
840     any value suggested as boot option. Otherwise, if a suggested value 
880 10.3 Advised boot setup commands
883 boot setup is:
889 boot setup can be:
903 to your boot setup command in order to check the actual setup the driver is 
906 10.4 PCI configuration fix-up boot option
936 10.5 Serial NVRAM support boot option
957     Verbose boot messages              N                   Y
963     Scan at boot time                  N                   Y
965 In order to speed up the system boot, for each device configured without 
966 the "scan at boot time" option, the driver forces an error on the 
969 Some SDMS BIOS revisions seem to be unable to boot cleanly with very fast 
973 The 'nvram' boot option can be entered in hexadecimal form in order 
980       0x08   ignore NVRAM "Scan at boot time" parameter for all devices
990 controller not to be attached by the ncr53c8xx driver at Linux boot, you 
991 must use the 'excl' driver boot option.
993 10.6 SCSI BUS checking boot option.
1007 10.7 IMMEDIATE ARBITRATION boot option
1024 the previous arbitration (boot option 'iarb:1').
1038 at compile time and the 'iarb' boot option to have been set to a non zero 
1039 value at boot time. It is not that useful for real work, but can be used 
1061 	Can be changed by the following boot setup command:
1075 	Transfer period factor the driver will use at boot time for synchronous 
1185 - Ask the driver to probe chip ids in reverse order from the boot command
1459 The Symbios NVRAM also holds data on the boot order of host adaptors in a
1466 NVRAM boot order settings can do this as well as change the order the same
1556         boot configuration -  56 bytes (4x14 bytes)
1586                        0x00000100 verbose boot msgs
1594 boot configuration
1596 boot order set by order of the devices in this table
1604        |  |  |  |     |         --0x01 init/scan at boot time
1648     0x00000010 - scan at boot time
1753                                             as BIOS dev    1 - boot device
1760                | | |              --------- boot delay     0 -   3 sec