Lines Matching refs:be

15   The given devices will be ignored by the common I/O-layer; no detection
16   and device sensing will be done on any of those devices. The subchannel to 
17   which the device in question is attached will be treated as if no device was
20   An ignored device can be un-ignored later; see the "/proc entries"-section for
23   The devices must be given either as bus ids (0.x.abcd) or as hexadecimal
25   give a device number 0xabcd, it will be interpreted as 0.0.abcd.
28   keywords can be used to refer to the CCW based boot device and CCW console
66   the device driver will be notified if possible, so the device will become
69   You can also add ranges of devices to be ignored by piping to 
73   Note: While already known devices can be added to the list of devices to be
74         ignored, there will be no effect on then. However, if such a device
75 	disappears and then reappears, it will then be ignored. To make
86   will be deregistered and thus removed from the system.
88   The devices can be specified either by bus id (0.x.abcd) or, for 2.4 backward
90   numbers given as 0xabcd will be interpreted as 0.0.abcd.
122   The level of logging can be changed to be more or less verbose by piping to