Lines Matching refs:method

64 The RapidIO subsystem defines the format and initialization method for subsystem
115 An enumeration/discovery method implementation and available input parameters
116 define how any given method can be attached to available RapidIO mports:
124   parameters. This was the original method used since introduction of RapidIO
125   subsystem. Now this method relies on enumerator module parameter which is
126   'rio-scan.scan' for existing basic enumeration/discovery method.
138   a command from user space. This initiation method provides more flexibility
169   to the method shown above, the host destination ID(s) can be specified using
196 Automatic enumeration/discovery start method is applicable only to built-in
198 enumeration/discovery start by existing basic enumerator method set use boot
208 When automatic enumeration/discovery start is selected, basic method's
213 enumeration/discovery start method may be difficult to use due to the
234 This is an original enumeration/discovery method which is available since
239 This method can be configured as statically linked or loadable module.
240 The method's single parameter "scan" allows to trigger the enumeration/discovery
243 This enumeration/discovery method can be started only once and does not support
306 A new enumeration/discovery method has to be attached to one or more mport
308 method's module initialization routine calls rio_register_scan() to attach