Lines Matching refs:put

21 Drivers will use one or both of these models to put devices into low-power
43 	Devices may also be put into low-power states while the system is
49 	operations on the device for this purpose.  Devices put into low power
62 have been put into low-power states (at runtime), the effect may be very similar
64 synergies exist, so that several drivers using runtime PM might put the system
198 they should be put into the full-power state.  Those interrupts may or may not
221 should and will) be put into a low-power state during a system-wide transition
328 	should not put the device into a low-power state.
345 	I/O.  They also may save the device registers and put it into the
357 	the device's registers that weren't saved previously and finally put the
482 	However the device does not have to be put in a low-power state, and to
487 	above, except that the device should not be put in a low-power state and
491 	above, except again that the device should not be put in a low-power
598 cases it generally is not possible to put devices into low-power states
599 individually.  Instead, a set of devices sharing a power resource can be put
601 power resource.  Of course, they also need to be put into the full-power state
689 transition, but in other cases the device must be put back into the full-power
694 During system-wide resume from a sleep state it's easiest to put devices into