Lines Matching refs:hibernation

1 Debugging hibernation and suspend
4 1. Testing hibernation (aka suspend to disk or STD)
6 To check if hibernation works, you can try to hibernate in the "reboot" mode:
11 and the system should create a hibernation image, reboot, resume and get back to
13 hibernation is most likely to work correctly.  Still, you need to repeat the
18 systems might be necessary to make hibernation work.  Thus, if your machine fails
24 which is the default and recommended mode of hibernation.
26 Unfortunately, the "platform" mode of hibernation does not work on some systems
27 with broken BIOSes.  In such cases the "shutdown" mode of hibernation might
36 If neither "platform" nor "shutdown" hibernation mode works, you will need to
39 a) Test modes of hibernation
41 To find out why hibernation fails on your system, you can use a special testing
43 there is the file /sys/power/pm_test that can be used to make the hibernation
66     and are only tested if the hibernation mode is set to "platform"
70 suspending devices) and issue the standard hibernation commands.  For example,
71 to use the "devices" test mode along with the "platform" mode of hibernation,
83 prepare the platform firmware for hibernation.  Next, it will wait a
85 methods used to cancel hibernation etc.
88 hibernation/suspend operations.  Also, when open for reading, /sys/power/pm_test
95 without creating a hibernation image.  Obviously, if the "devices" test fails,
118 them), you have to unload it every time before hibernation.  In that case please
129 of hibernation is not likely to work.  You can try the "shutdown" mode, but that
150 If all of the hibernation test modes work, you can boot the system with the
165 before hibernation, and please report the problem with it(them).
169 In case that hibernation does not work on your system even in the minimal
190 hibernation, so please refer to Section 1 for more information about them.  In