Lines Matching refs:that

29 to tell the parport code that you want three PC-style ports, one at
51 Note that these are example lines only!  You shouldn't in general need
62 port is detected, the devices that are connected to it are analysed,
82 command-line will make parport use any IRQ lines or DMA channels that
93 describing that parallel port.
135 devices/active	A list of the device drivers using that port.  A "+"
138 		string "none" means that there are no device drivers
139 		using that port.
164 		Note that the current implementation will only take
168 autoprobe	Any IEEE-1284 device ID information that has been
172 		daisy-chain devices that conform to IEEE 1284.3.
175 		for the peripheral to respond.  You might find that
180 timeslice	The number of milliseconds that a device driver is
204 Both the above examples would inform lp that you want /dev/lp0 to be
207 that this is different to the way older kernels worked; there used to
217    only for those ports that seem to have printers attached.
221    it will avoid any ports that seem to be in use by other devices.
232 the messages that parport_pc spits out when it initialises.  There are
240 The kernel messages that parport_pc logs give an indication of which
247 CONFIG_PARPORT_PC_FIFO.  Note that when they are enabled they are not
255 If that works fine, try with 'io=0x378 irq=7' (adjust for your