Lines Matching refs:it

42 If you use modprobe , you will find it useful to add lines as below to a
62 port is detected, the devices that are connected to it are analysed,
83 it auto-detects.
137 		the port (it might not appear against any).  The
165 		advantage of COMPAT and ECP modes if it has an IRQ
177 		peripherals.  This is a port-wide setting, i.e. it
182 		and driver can ignore it if it must.
185 		port is	registered, it picks up the default spintime.
186 		When a new device is registered, it picks up the
194 is loaded it will create one lp device for each port found.  You can
210 case - if you only have one port, it will default to being /dev/lp0,
221    it will avoid any ports that seem to be in use by other devices.
232 the messages that parport_pc spits out when it initialises.  There are
248 necessarily _used_; it depends on whether the hardware is available,
256 hardware), to make it use interrupt-driven in-software protocol.
259 right.  Enable CONFIG_PARPORT_PC_FIFO (no, it isn't a module option,
260 and yes, it should be), set the port to ECP mode in the BIOS and note