Lines Matching refs:parameter
33 The default value for each parameter is generally the recommended setting,
51 This parameter is a bit-mask that specifies the speed and duplex settings
52 advertised by the adapter. When this parameter is used, the Speed and
56 information on the AutoNeg parameter.
75 This parameter controls the automatic generation(Tx) and response(Rx)
209 (This parameter is supported only on 82540, 82545 and later adapters.)
222 (This parameter is supported only on adapters with copper connections.)
227 (Mbps). If this parameter is not specified or is set to 0 and the link
269 module parameter.
272 not be resolved by the use of the TxDescriptorStep parameter. As the
273 issue addressed by this parameter has never been observed on Intel
289 (This parameter is supported only on 82540, 82545 and later adapters.)
302 (This parameter is NOT supported on the 82542-based adapter.)
318 This parameter is different than other parameters, in that it is a
319 single (not 1,1,1 etc.) parameter applied to all driver instances and
329 this parameter in supported chipsets.
358 negotiation is disabled, and the AutoNeg parameter is ignored. Partner
361 The AutoNeg parameter is used when more control is required over the
366 The parameter may be specified as either a decimal or hexadecimal value as
387 Note that when this parameter is used, Speed and Duplex must not be specified.
390 parameter should not be used. Instead, use the Speed and Duplex parameters