Lines Matching refs:or
25 website. In the search field, enter your adapter name or type, or use the
65 either one or two-directional. If both Duplex and the link partner are
67 link partner is forced (either full or half), Duplex defaults to half-
80 (not supported on Intel(R) 82542, 82543 or 82544-based adapters)
90 Setting InterruptThrottleRate to a value greater or equal to 100
102 Since 7.3.x, the driver has two adaptive modes (setting 1 or 3) in which
112 for small amounts of traffic and/or a significant percentage of small
113 packets; and "Lowest latency", for almost completely small packets or
118 latency" or "Lowest latency" class, the InterruptThrottleRate is increased
121 For situations where low latency is vital such as cluster or
130 traffic is mostly transmit or mostly receive, the interrupt rate could
139 and/or transmit absolute delays does not force the controller to
179 descriptor and can be either 2048, 4096, 8192, or 16384 bytes, depending
227 (Mbps). If this parameter is not specified or is set to 0 and the link
229 speed. Duplex should also be set when Speed is set to either 10 or 100.
259 memory cache-line, which is typically 32 bytes, or 4 descriptors long.
315 Driver copies all packets below or equaling this size to a fresh RX
357 If Speed = 10 or 100, then both Speed and Duplex should be set. Auto-
366 The parameter may be specified as either a decimal or hexadecimal value as
380 modprobe e1000 AutoNeg=0x03 (Restricts autonegotiation to 10 Half or 10 Full)
382 modprobe e1000 AutoNeg=0x05 (Restricts autonegotiation to 10 Half or 100
416 size and/or increasing the /proc/sys/net/ipv4/tcp_*mem entry values may help.
423 - Using Jumbo frames at 10 or 100 Mbps is not supported and may result in
424 poor performance or loss of link.
435 version 1.6 or later is required for this functionality.
444 WoL will be enabled on the system during the next shut down or reboot.
446 loaded when shutting down or rebooting the system.
455 or the Intel Wired Networking project hosted by Sourceforge at: