Lines Matching refs:test

379 the CS8900/20 Setup Utility can be used to test the functionality of the 
381 test the functionality of the adapter with the hardware configuration you have
382 assigned. You can use the diagnostics 'Network Test' to test the ability of the
400        * Select 'Self-Test' to test the adapter's basic functionality.
401        * Select 'Network Test' to test the network connection and cabling.
406 The diagnostic self-test checks the adapter's basic functionality as well as 
411      The IO Register Read/Write test insures that the CS8900/20 can be 
415      The Shared Memory test insures the CS8900/20 can be accessed in memory 
420      The Interrupt test insures there are no conflicts with the assigned IRQ
424      The EEPROM test insures the EEPROM can be read.
427      The Chip RAM test insures the 4K of memory internal to the CS8900/20 is
431      The Internal Loop Back test insures the adapter's transmitter and 
432      receiver are operating properly.  If this test fails, make sure the 
437      The Boot PROM  test insures the Boot PROM is present, and can be read.
443 Failure of a test item indicates a possible system resource conflict with 
453 on the same network. (Note: the diagnostic network test should not be run 
456 This test requires that each of the two PCs have a CS8900/20-based adapter
464 transmitted OK or in error.  The test can be terminated anytime by the user at 
474     2.) Return to the PC with the CS8900/20-based adapter you want to test and
478         Hit ENTER to start the test.
480 You may stop the test on the Initiator at any time while allowing the Responder
481 to continue running.  In this manner, you can move to additional PCs and test 
518 diagnostic self-test.  Normally, the ISA resource in conflict will fail the 
519 self-test.  If so, reconfigure the adapter selecting another choice for the 
526 diagnostics self-test to ensure the new configuration is free of conflicts