Lines Matching refs:primary

537 		This mode provides fault tolerance.  The primary
693 primary
696 	primary device.  The specified device will always be the
697 	active slave while it is available.  Only when the primary is
702 	The primary option is only valid for active-backup(1),
707 	Specifies the reselection policy for the primary slave.  This
708 	affects how the primary slave is chosen to become the active slave
709 	when failure of the active slave or recovery of the primary slave
711 	the primary slave and other slaves.  Possible values are:
715 		The primary slave becomes the active slave whenever it
720 		The primary slave becomes the active slave when it comes
721 		back up, if the speed and duplex of the primary slave is
727 		The primary slave becomes the active slave only if the
728 		current active slave fails and the primary slave is up.
735 		When initially enslaved, the primary slave is always made
1517 	bond-primary eth0 eth1
1533 	bond-primary eth0 eth1
1538 	bond-primary eth0 eth1
2031 "primary."  This slave is used for mode-specific control traffic, for
2101 	then the primary option can be used to insure that the
2262 	connected to the same peer as the primary.  In this case, a
2588 	The Serial Over LAN (SoL) link is established over the primary