Lines Matching refs:etc
142 /etc/modrobe.d/*.conf configuration files, or in a distro-specific
695 A string (eth0, eth2, etc) specifying which slave is the
950 First, look for a file called interfaces in /etc/network directory.
1012 lines (USERCTL, etc).
1080 # /etc/init.d/network restart
1095 /etc/sysconfig/network/ifcfg.template
1123 the system /etc/modules.d/*.conf configuration files.
1130 version 3 or later, Fedora, etc. On these systems, the network
1142 /etc/sysconfig/network-scripts
1146 for eth0 would be named /etc/sysconfig/network-scripts/ifcfg-eth0.
1165 script will be /etc/sysconfig/network-scripts/ifcfg-bondX where X is
1200 options via BONDING_OPTS, it is not necessary to edit /etc/modprobe.d/*.conf.
1203 BONDING_OPTS, it is necessary to edit /etc/modprobe.d/*.conf, depending upon
1205 bond0 interface is brought up. The following lines in /etc/modprobe.d/*.conf
1214 Finally run "/etc/rc.d/init.d/network restart" as root. This
1252 module parameters into a config file in /etc/modprobe.d/ (as
1256 /etc/init.d/boot.local and for initscripts it is /etc/rc.d/rc.local.
1260 reboots, edit the appropriate file (/etc/init.d/boot.local or
1261 /etc/rc.d/rc.local), and add the following:
1270 network configuration (IP address, netmask, etc) with the appropriate
1277 # /etc/init.d/boot.local
1281 # /etc/rc.d/rc.local
1328 sets of bonding options in /etc/modprobe.d/*.conf, for example:
1467 file (/etc/init.d/boot.local or /etc/rc.d/rc.local), and add the
1494 This section applies to distros which use /etc/network/interfaces file
1501 into /etc/network/interfaces.
1509 In /etc/network/interfaces, the following stanza will configure bond0, in
1521 Ubuntu versions. The following stanza in /etc/network/interfaces will
1540 For a full list of bond-* supported options in /etc/network/interfaces and some
1802 those slaves will stay down. If networking monitoring (tcpdump, etc)
1900 /etc/modprobe.d/.
1929 /etc/modprobe.d/ as:
2100 a backup switch (e.g., has lower capacity, higher cost, etc),
2741 etc. at www.scyld.com.