Lines Matching refs:MII

66 7.3	MII Monitor Operation
483 	Specifies the MII link monitoring frequency in milliseconds.
485 	inspected for link failures.  A value of zero disables MII
777 	Specifies whether or not miimon should use MII or ETHTOOL
779 	status. The MII or ETHTOOL ioctls are less efficient and
791 	MII / ETHTOOL ioctl method to determine the link state.
794 	0 will use the deprecated MII / ETHTOOL ioctls.  The default
1441 To enable MII monitoring on bond0 with a 1 second interval:
1443 	NOTE: If ARP monitoring is enabled, it will disabled when MII
1571 MII Status: up
1572 MII Polling Interval (ms): 0
1577 MII Status: up
1583 MII Status: up
1642         MII Status: up
1643         MII Polling Interval (ms): 1000
1648         MII Status: up
1652         MII Status: up
1781 monitoring a slave device's link state: the ARP monitor and the MII
1785 bonding driver itself, it is not possible to enable both ARP and MII
1829 7.3 MII Monitor Operation
1832 	The MII monitor monitors only the carrier state of the local
1835 querying the device's MII registers, or by making an ethtool query to
1839 then the MII monitor will rely on the driver for carrier state
1841 use_carrier parameter information, above, if the MII monitor fails to
1846 	If use_carrier is 0, then the MII monitor will first query the
1847 device's (via ioctl) MII registers and check the link state.  If that
1848 request fails (not just that it returns carrier down), then the MII
1851 does not support or had some error in processing both the MII register
1852 and ethtool requests), then the MII monitor will assume the link is
1884 interface basis), and is discarded.  The MII monitor is not affected
1955 fixed interval, but does not cache the MII register values (so the
2116 failures, then either the MII or ARP monitors should work.  For
2118 end, the MII monitor has no direct means to detect this.  The ARP
2310 	Finally, the 802.3ad mode mandates the use of the MII monitor,
2347 the MII monitor (which does not provide as high a level of end to end
2401 	Again, in actual practice, the MII monitor is most often used
2404 advantages over the MII monitor are mitigated by the volume of probes
2578 ports and the devices on the JS20 system itself.  The MII monitor is
2581 	When a passthrough module is in place, the MII monitor does
2740 You will also find a lot of information regarding Ethernet, NWay, MII,