Lines Matching refs:be

15 At back side of transmitter S-video connector can be found. Modulation
16 pulses from processor to HF part can be found at pin 2 of this connector,
17 pin 3 is GND. Between pin 3 and CPU 5k6 resistor can be found. To get
18 modulation pulses to PC, signal pulses must be amplified.
39 access to parport, modules like lp must be unloaded before loading
42 be changed by TX "joystick", check output from /proc/interrupts. Value for
85 One binary and octal value can be grouped to nibble. 24 nibbles + one binary
86 values can be sampled between sync pulses.
88 Values for first four channels (analog joystick values) can be found in
93 Next nibbles 12 .. 21 represents four channels (not all channels can be
99 binary value can be sampled. This bit and magic number is not used in
100 software driver. Some details about this magic numbers can be found in
105 Summary of octal values in nibbles must be same as octal value in checksum