Lines Matching refs:joystick

11 happen include burning your parallel port, and/or the sticks and joystick
16   The joystick parport drivers are used for joysticks and gamepads not
47 for your pads, use either keyboard or joystick port, and make a pass-through
139 for joystick ports. They were all digital, and all used D-Cannon 9 pin
140 connectors (db9). Because of that, a single joystick could be used without
223 was written. It allows only one joystick / gamepad per parallel port, but
226   For the basic 1-button Multisystem joystick you connect its wires to the
238   However, if the joystick is switch based (eg. clicks when you move it),
257 the digital joystick driver 0.8.0.2, this is also supported by the db9.c
262   For some people just one joystick per parallel port is not enough, and/or
270 joystick can do more (eg. turbofire) you'll need to disable it totally first
288   And finally, you connect the Ground wire of the joystick, like done in
291 for each joystick. The power source is shared.
306 Steffen's version, there is support for up to 5 buttons per joystick.  However,
308 supports only one button per joystick. For more information on how to build the
342 Multisystem joystick. However, since they don't use switches and use TTL
451 	  4  | Multisystem 1-button joystick
452 	  5  | Multisystem 2-button joystick
485   'Type' is the type of joystick or pad attached:
490 	  1  | Multisystem 1-button joystick
491 	  2  | Multisystem 2-button joystick
496 	  8  | Multisystem 1-button joystick (v0.8.0.2 pin-out)
513 interface ports 1-7 have. For a standard multisystem joystick, this is 1.