Lines Matching refs:temperature

53 The chips implement 3 to 4 temperature sensors (9 for NCT6775F and NCT6776F),
58 The temperature sensor sources on W82677HG-B, NCT6775F, and NCT6776F are
59 configurable. temp4 and higher attributes are only reported if its temperature
60 source differs from the temperature sources of the already reported temperature
61 sensors. The configured source for each of the temperature sensors is provided
67 An alarm is triggered when the temperature gets higher than high limit;
68 it stays on until the temperature falls below the hysteresis value.
83 In this mode, the chip attempts to keep the measured temperature in a
84 predefined temperature range. If the temperature goes out of range, fan
106 pwm[1-4]_enable - this file controls mode of fan/temperature control:
131 If the temperature is in the range defined by:
133 pwm[1-4]_target    - set target temperature, unit millidegree Celsius
137 there are no changes to fan speed. Once the temperature leaves the interval,
141 pwm[1-4]_min_output - minimum fan speed (range 1 - 255), when the temperature
144                       corresponding fan off. (when the temperature was below
149 pwm[1-4]_max_output - maximum fan speed (range 1 - 255), when the temperature
164 0x49:  only on DHG, selects temperature source for AUX fan, CPU fan0
166        different behavior to bits 7 and 6, including extending the temperature
171 0x5e:  only on DHG, has bits to enable "current mode" temperature detection and
172        critical temperature protection
177 0x6b:  only on DHG, SYS fan critical temperature
178 0x6c:  only on DHG, CPU fan0 critical temperature
179 0x6d:  only on DHG, AUX fan critical temperature
180 0x6e:  only on DHG, CPU fan1 critical temperature