Lines Matching refs:temperature

45 The chips support up to 25 temperature monitoring sources. Up to 6 of those are
46 direct temperature sensor inputs, the others are special sources such as PECI,
47 PCH, and SMBUS. Depending on the chip type, 2 to 6 of the temperature sources
54 The temperature sensor sources on all chips are configurable. The configured
55 source for each of the temperature sensors is provided in tempX_label.
58 either 1 degC or 0.5 degC, depending on the temperature source and
59 configuration. An alarm is triggered when the temperature gets higher than
60 the high limit; it stays on until the temperature falls below the hysteresis
78 In this mode, the chip attempts to keep the measured temperature in a
79 predefined temperature range. If the temperature goes out of range, fan
90 pwm[1-5]_enable - this file controls mode of fan/temperature control:
105 pwm[1-5]_temp_sel	Temperature source. Value is temperature sensor index.
108 			Secondary temperature source. Value is temperature
110 			Set to 0 to disable secondary temperature control.
112 If secondary temperature functionality is enabled, it is controlled with the
122 			Temperature at which secondary temperature control kicks
130 If the temperature is in the range defined by:
132 pwm[1-5]_target_temp	Target temperature, unit millidegree Celsius
135 			Target temperature tolerance, unit millidegree Celsius
137 there are no changes to fan speed. Once the temperature leaves the interval, fan
138 speed increases (if temperature is higher that desired) or decreases (if
139 temperature is lower than desired), using the following limits and time
143 			when the temperature is above defined range.
144 pwm[1-5]_floor		lowest fan pwm (range 0 - 255) if temperature is below
146 			stop if the temperature is below the defined range.
150 			corresponding fan off (when the temperature was below
169 controlled by setting the pwm and temperature attributes. When the temperature
173 higher fan speeds with increasing temperature. The last data point reflects
174 critical temperature mode, in which the fans should run at full speed.
177 			pwm value to be set if temperature reaches matching
178 			temperature range.
184 			Temperature tolerance for critical temperature,
195 temperature measurement device. As a result, the temperature reported on CPUTIN
197 temperatures, and in some cases the reported temperature declines if the actual
198 temperature increases (similar to the raw PECI temperature value - see PECI
200 boards. The CPU temperature on ASUS boards is reported from PECI 0.