Lines Matching refs:kernel

6 Updated 2006 by Nico Schottelius <nico-kernel-nfsroot@schottelius.org>
29 In the networking options, kernel level autoconfiguration can be selected,
39 When the kernel has been loaded by a boot loader (see below) it needs to be
42 This can be established using the following kernel command line parameters:
48   real device but just a synonym to tell the kernel to use NFS instead of
84   This parameter tells the kernel how to configure IP addresses of devices
90   If this parameter is missing from the kernel command line, all fields are
92   this means that the kernel tries to configure everything using
147 		into the kernel will be used, regardless of the value of
152 		  on or any:   use any protocol available in the kernel
172   This parameter enables debugging messages to appear in the kernel
183   file exists and the kernel can execute it, root filesystem related
184   kernel command line parameters, including `nfsroot=', are ignored.
197 To get the kernel into memory different approaches can be used.
206      	FDARGS parameter which can be used to set the kernel command line.
217 	N.B: Previously it was possible to write a kernel directly to
227      	parameter which can be used to set the kernel command line.
255 	When using GRUB, kernel parameter are simply appended after the kernel
256 	specification: kernel <kernel> <parameters>
262 	it should be possible configure the kernel command line similarly
269 	With a boot ROM the kernel is loaded using the TFTP protocol. The
280 	When using pxelinux, the kernel image is specified using
281 	"kernel <relative-path-below /tftpboot>". The nfsroot parameters
282 	are passed to the kernel by adding them to the "append" line.
295   The nfsroot code in the kernel and the RARP support have been written