Lines Matching refs:be
9 - reset-gpios: a GPIO spec for the reset pin. If specified, it will be
13 it will be deasserted before communication to the codec
27 If parameter is missing, mode 0 will be enabled.
28 This property has to be specified as '/bits/ 8' value.
37 This properties have to be specified as '/bits/ 8' values.
46 If present, then fault recovery will be enabled.
50 configured. Must be one of these values:
60 The value must be in the range of 0..300, and only
80 channels. If not present, normal PWM spped mode (384 kHz) will be used.
90 If present, a mute output will be activated in ase the volume will
94 If present, the bridge will be switched off immediately after the
108 If present, the bridge power-down time will be divided by the provided
109 value. If not specified, a divider of 1 will be used. Allowed values
111 This property has to be specified as '/bits/ 8' value.