Lines Matching refs:pin

1 *ST pin controller.
3 Each multi-function pin is controlled, driven and routed through the
4 PIO multiplexing block. Each pin supports GPIO functionality (ALT0)
6 the pin to different hardware blocks.
8 When a pin is in GPIO mode, Output Enable (OE), Open Drain(OD), and
12 gpio driver to configure a pin.
36 - st,retime-pin-mask	: Should be mask to specify which pins can be retimed.
40 - ranges : defines mapping between pin controller node (parent) to gpio-bank
53 - #gpio-cells	  : Should be one. The first cell is the pin number.
78 	pin-controller-sbc {
98 		pin-functions nodes follow...
104 Required properties for pin configuration node:
107 Below is the format of how each pin conf should look like.
116 -mux		: Should be alternate function number associated this pin.
118 -mode		:pin configuration is selected from one of the below values.
125 -rt_type	Retiming Configuration for the pin.
147 Example of mmcclk pin which is a bi-direction pull pu with retime config
150 pin-controller {