Lines Matching refs:in
10 - pinctrl-single,register-width : pinmux register access width in bits
13 in the pinmux register
25 drive strength in the pinmux register. They're value of drive strength
32 input bias pullup in the pinmux register.
38 input bias pulldown in the pinmux register.
48 enable bit should be included in pullup or pulldown bits.
54 input schmitt in the pinmux register. In some silicons, there're two input
55 schmitt value (rising-edge & falling-edge) in the pinmux register.
61 configure input schmitt enable or disable in the pinmux register.
74 range. They're value of subnode phandle, pin base in pinctrl device, pin
75 number in this range, GPIO function value of this GPIO range.
91 specified in the pinctrl-bindings.txt document in this directory.
95 specified in pinctrl-single,function-mask are updated. For example, setting
115 Optional sub-node: In case some pins could be configured as GPIO in the pinmux
119 Required properties in sub-node:
120 - #pinctrl-single,gpio-range-cells : the number of parameters after phandle in
132 /* first controller instance for pins in core domain */
144 /* second controller instance for pins in wkup domain */
166 /* third controller instance for pins in gpio domain */
195 * itself during the boot (or just set them up in the bootloader)