Lines Matching refs:in
3 The pins controlled by mxs pin controller are organized in banks, each bank
13 Please refer to pinctrl-bindings.txt in this directory for details of the
21 actually tristates in this binding: unspecified, off, or on. Unspecified is
27 configurations, and it's called group node in the binding document. The other
29 different configuration than what is defined in group node. The binding
32 On mxs, there is no hardware pin group. The pin group in this binding only
33 means a group of pins put together for particular peripheral to work in
36 having these pins defined in several group nodes. It also means each of
37 "pinctrl-*" phandle in client device node should only have one group node
38 pointed in there, while the phandle can have multiple config node referenced
39 there to adjust configurations for some pins in the group.
42 - fsl,pinmux-ids: An integer array. Each integer in the array specify a pin
50 and config nodes to identify a pin. The mux selection in the integer takes
57 is required only for group nodes, and should not be present in any config
74 Also, some pins doesn't have a pull up, in that case, setting the fsl,pull-up
122 to be listed in the config nodes.
124 Valid values for i.MX28/i.MX23 pinmux-id are defined in
126 The definitions for the padconfig properties can be found in