Lines Matching refs:tape
91 SCSI tape drive and medium changer support
97 You must enable "SCSI tape drive support for Smart Array 5xxx" and
99 tape drives with your Smart Array 5xxx controller.
102 time if any tape drives or medium changers are detected. The driver may
121 Hot plug support for SCSI tape drives
124 Hot plugging of SCSI tape drives is supported, with some caveats.
149 controller in the same way that we are allowing it to access SCSI tape drives.
151 SCSI error handling for tape drives and medium changers
162 driver as well as a SCSI driver and only the tape drives and medium
167 resetting the device. Additionally, most tape drives will not oblige
173 In the event the error handling code is triggered and a tape drive is
175 tape drive may still not allow i/o to continue until some command
176 is issued which positions the tape to a known position. Typically you
177 must rewind the tape (by issuing "mt -f /dev/st0 rewind" for example)
178 before i/o can proceed again to a tape drive which was reset.
181 allocate more commands for use by tape drives. Ordinarily only a few commands
182 (6) are allocated for tape drives because tape drives are slow and
185 are allocated for disk devices. However, if you have more than a few tape
187 enought (for example, if you have 8 tape drives, you could only rewind 6
190 tape drives. For example: