Lines Matching refs:then

25 of a bus disconnection, and then performing error recovery.
47 again notified, so that they may then perform any device setup/config
105 For example, if mmio_enabled() and resume() aren't there, then it
154 then the platform should re-enable IOs on the slot (or do nothing in
159 then recovery proceeds to STEP 4 (Slot Reset).
178 >>> and prints an error to syslog.  A reboot is then required to 
184 DMA), and then calls the mmio_enabled() callback on all affected
227 If all drivers returned PCI_ERS_RESULT_RECOVERED, then the platform
230 If any driver returned PCI_ERS_RESULT_NEED_RESET, then the platform
235 The platform resets the link, and then calls the link_reset() callback
244 check its recoverability status. If all is right, then the platform
250 The platform then proceeds to either STEP 4 (Slot Reset) or STEP 5
267 Powerpc soft reset consists of asserting the adapter #RST line and then
282 If the platform supports PCI hotplug, then the reset might be
306 cycle) and then call slot_reset() again.  It the device still can't
361 higher layers. The device driver should then clean up all of its