usb 1-3: new high speed USB device using ehci_hcd and address 3
usb 1-3: configuration #1 chosen from 1 choice
eth1: register 'asix' at usb-0000:00:13.2-3, ASIX AX88178 USB 2.0 Ethernet, 00:24:a5:68:03:21
usb 1-3: New USB device found, idVendor=0411, idProduct=006e
usb 1-3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-3: Manufacturer: BUFFALO INC.       
usb 1-3: SerialNumber: 0005B5
eth1: link up, 1000Mbps, full-duplex, lpa 0xCDE1
eth1: link up, 1000Mbps, full-duplex, lpa 0xCDE1

T:  Bus=01 Lev=01 Prnt=01 Port=02 Cnt=01 Dev#=  3 Spd=480 MxCh= 0
D:  Ver= 2.00 Cls=ff(vend.) Sub=ff Prot=00 MxPS=64 #Cfgs=  1
P:  Vendor=0411 ProdID=006e Rev= 0.01
S:  Manufacturer=BUFFALO INC.       
S:  SerialNumber=0005B5
C:* #Ifs= 1 Cfg#= 1 Atr=a0 MxPwr=450mA
I:* If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=ff Prot=00 Driver=asix
E:  Ad=81(I) Atr=03(Int.) MxPS=   8 Ivl=128ms
E:  Ad=82(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=03(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms